Tips to Increase your Refrigerator Cooling & Efficiency Leave a comment

Introduction

A refrigerator is an essential appliance in every household. It keeps food fresh and prevents it from spoiling. However, at times, the cooling may not be adequate, and the food may not stay fresh for long. In this article, we will discuss some tips to increase the cooling of your refrigerator and keep your food fresh for a longer time.

Check the Refrigerator Gasket

The first step in increasing the cooling of your refrigerator is to check the seal of the door. A damaged or worn-out seal can cause the cool air to escape, resulting in poor cooling. To check the seal, place a piece of paper between the door and the fridge. If you can pull the paper out easily, the seal needs to be replaced.

Clean the Condenser Coils

The condenser coils of your refrigerator are responsible for dissipating the heat generated by the compressor. If these coils are dirty, they may not function properly, leading to poor cooling. To clean the coils, unplug the refrigerator and locate the coils at the back or bottom of the unit. Use a coil cleaning brush or a vacuum cleaner with a brush attachment to remove the dirt and dust from the coils.

Adjust the Temperature Settings

If the temperature settings of your refrigerator are not set correctly, it can lead to poor cooling. The average recommended  temperature for a refrigerator is between 1 to 4 Degree and Freezer is –17 to –20 Degree. You can adjust the temperature settings by using the thermostat control located inside the fridge or on the control panel.

Check for Low Voltage:

If the voltage supply to your refrigerator is low, it can cause the compressor to work harder and make the refrigerator less efficient at cooling. To check the voltage, use a voltmeter to measure the voltage at the outlet where the refrigerator is plugged in. If it is lower than 180 volts then you should install a stabilizer to your refrigerator. Nowadays most refrigerators are coming with low voltage startup.

Keep the Refrigerator Fully Stocked

A full refrigerator retains the cool air better than an empty one. When the fridge is empty,the thermostat trips your refrigerator faster and the cool air escapes quickly, leading to poor cooling. To increase the cooling of your refrigerator, make sure to keep it fully stocked.

Avoid Keeping Hot Food

Putting hot food in the refrigerator can cause the compressor to work harder, leading to poor cooling. To increase the cooling of your refrigerator, avoid keeping hot food in it. Instead, allow the food to cool to room temperature before storing it in the fridge.

Keep the Fridge away from heat sources

The refrigerator should be placed away from heat sources such as ovens, dishwashers, or direct sunlight, as this can cause the compressor to work harder and reduce the cooling efficiency. Keeping the refrigerator away from heat sources can have several benefits, including improving cooling efficiency, reducing energy consumption and extending the lifespan of the refrigerator.

Keep the refrigerator door closed as much as possible

Every time the door is opened, warm air enters and cool air escapes. This causes the compressor to work harder, reducing the cooling efficiency. By keeping the door closed as much as possible, the refrigerator can maintain the desired temperature more efficiently as well as it can also reduce your electricity bill and better food preservation.

Conclusion

In conclusion,by following the tips discussed in this article, you can increase the cooling of your refrigerator and keep your food fresh for a longer time. These include checking the seal, cleaning the condenser coils, adjusting the temperature settings, keeping the refrigerator fully stocked, and avoiding keeping hot food in it.